The Limatherm TTJU-45 or TTKU-45 rubber mix temperature sensor is mounted at the rubber mix door. A special narrowed tip enhances the sensor reaction time to temperature change. The tip is covered with a protective layer that increases abrasion resistance.A flexible,mineral insulated measuring insert is included inside the Thermowell. It can be replaced without the need to disassemble the whole sensor.

Temperature sensors with flexible cable for measurement of liquid and gaseous media in severe environmental conditions, especially for measurement of exhaust fumes in marine engines.

HVAC sensors for temperature measurement in buildings, offices, radiator surfaces, industrial work spaces, semi-liquids and lose materials, ventilation channels, open spaces with optional 4-20mA transmitter.

For high temperature applications (1200°C - 1700°C or higher) for

• molten metal or glass
• melted light alloys
• oil fired or plast furnaces
• Ethylene crackers
• brick or calcinating cement kilns

Limatherm offers solutions with special Thermocouple inserts, ceramic or high grade metal protection tubes.

Biogas measurement provides gas quantity output data, detects the efficiency of a fermentation tank, controls combustion efficiency of the boiler and monitors greenhouse gas emission (CH4 and CO2).

Raw Biogas is usually measured with a low flow rate and pressure of 50-60 mbar and an ambient temperature rising to 50°C after fermentation. Water-saturated biogas can cause 5-6 vol % liquid water in the pipe after cooling down. Particles can cause clogging. Water vapor and H2S forms a corrosive acid. Backflow and scaling of bacteria may appear. Hazardous area certification is required.